NZMO Issues

[ardypilot]

Wondering if anyone can help me raise my sunken airfield at NZMO.



I had obviously tried to install Mikes NZMO with Orbx at some time in the past- however, his files are deactivated in my scenery library, and the 'FBP_FTX_NZSI_NZMO.bgl' file in the FTX_NZSI_05_SCENERY/Scenery directory is where it should be.

Any ideas? The runway is completely invisible at ground level if that makes any difference. Cheers!

[Ian Warren]

I had few issues again with elevations .. get back to ya with an install.

Edit: I have the elevation problem - scenery below I'll have a play see what causing this - one thing I do use in this area is Robins Tikitimu .

[toprob]

I'm not sure if this applies to Mike's airport, but if disabling the scenery doesn't put the elevation back where it was, then check Scenery\World\Scenery for an elevation stub for NZMO -- there should be only one, in this case the FTX stub.

[Ian Warren]

Above as Rob said BUT, if you own global FTX and also want to run the entire NZSI/NI and to show glitch's with Orbx switch's don't work ... I need the Global to fix the gable roof problem if doing autogen areas , so I need to run both and this proves this switch don't work ... You will see below I had to manually rename the file from - OFF - to BGL and then it kicks in and elevation correct themselves.

I now can fix my own issues - example : bottom of the screen

[emfrat]

With my FTX_AU , I arranged things so the FTX Central switcher switched back in the same files it just switched out, if you see wot I mean.
No more yellow buildings, no more duff roofs.

[Ian Warren]

I did not touch any any AU scenery , just confirmed to run both Global to fix the the "duff" roofs, yellow building , "little corner shop dairies" I called them .

Following Andy problem , I mentioned working on Greymouth I mentioned to Doug was below level .. I renamed the file OFF to a BGL and Voila ... to confirm this Alexandria I had the same issue so all good news .

[ardypilot]

Ah yes, found a folder hidden away that I'd created and forgotten about with the required .BGL's. All sorted now, thanks guys.