Wierd Problem in Marlborough

The place to ask for help or solve each others technical issues and discuss hardware

Postby lowglow » Sun Dec 08, 2013 12:45 pm

While flying around the Marlborough region today I discovered a problem with Woodbourne I have VLC and RealNZ Marlb installed. When I landed at Woodbourne after slowing to a taxis speed I noted the Aircraft hopping up and down every 5 seconds or so plane also wanted to run backwards if the brakes were not applied. I turned of RealNZ Malb in the scenery library then I found that there was only a short section of runway visible just big enough for the aircraft to sit on still hopping up and down then rolled backwards and feel through the ground. I reset the flight starting at Omaka no RealNZ took off and headed for Woodbourne as I approached Woodbourne I noted lights and runway visible (lights are not there with RealNZ another problem) but as I got closer the runway began to slowly disappear leaving again the short piece of runway the ground around this part of the runway was not flat but hilly and I plane flew under the ground and disappeared when I landed.
Got any Ideas on this one.
Image Image

Image


Image
User avatar
lowglow
Sim-holic
 
Topic author
Joined: Mon Jul 06, 2009 9:42 pm
Posts: 538
Location: Blenheim New Zealand

Postby toprob » Sun Dec 08, 2013 1:49 pm

It certainly sounds like there's something missing, or something doubled-up. Tracking it down is the tricky bit...
You can't just disable the scenery folder without disabling the extra file in Scenery\World\Scenery. (just search for NZWB.)
There are normally two solutions with this sort of problem:

You have a doubled-up scenery file somewhere, normally something like a Facilities file (what we used to call AFCADs) installed by something else. So the first step is to search your FSX installation for anything with 'NZWB' in the filename. if you find anything outside the RealNZmarl folder, or the one in Scenery\World\Scenery, then this is probably the culprit.

Or you don't have the elevation file in Scenery\World\Scenery, in which case you'd need to reinstall it.
Last edited by toprob on Sun Dec 08, 2013 1:50 pm, edited 1 time in total.
User avatar
toprob
NZFF Pro
 
Joined: Sat Apr 29, 2006 4:56 pm
Posts: 6711
Location: Upper Hutt

Postby lowglow » Sun Dec 08, 2013 2:05 pm

Thanks for that I will start looking.
I have now noticed a problem with Omaka as well I just took a flight from there and found that the whole of the Omaka area was covered in a blue sheet looked like water but you could look below it and see the green ground.
Image Image

Image


Image
User avatar
lowglow
Sim-holic
 
Topic author
Joined: Mon Jul 06, 2009 9:42 pm
Posts: 538
Location: Blenheim New Zealand

Postby Splitpin » Sat Dec 14, 2013 5:55 pm

The only problem i know of in Marlborugh is ...... Big D , but he's not wierd winkyy.gif (most of the time) tongue.gif
User avatar
Splitpin
NZFF Pro
 
Joined: Mon Aug 03, 2009 12:15 pm
Posts: 21332
Location: Christchurch NZ

Postby lowglow » Sat Dec 14, 2013 8:01 pm

Splitpin wrote:
QUOTE (Splitpin @ Dec 14 2013,6:55 PM) <{POST_SNAPBACK}>
The only problem i know of in Marlborugh is ...... Big D , but he's not wierd winkyy.gif (most of the time) tongue.gif

Ha nice
Image Image

Image


Image
User avatar
lowglow
Sim-holic
 
Topic author
Joined: Mon Jul 06, 2009 9:42 pm
Posts: 538
Location: Blenheim New Zealand

Postby Ian Warren » Sun Dec 15, 2013 12:05 am

Splitpin wrote:
QUOTE (Splitpin @ Dec 14 2013,6:55 PM) <{POST_SNAPBACK}>
The only problem i know of in Marlborugh is ...... Big D , but he's not wierd winkyy.gif (most of the time) tongue.gif

WINK ! biggrin.gif

lowglow wrote:
QUOTE (lowglow @ Dec 14 2013,9:01 PM) <{POST_SNAPBACK}>
Ha nice

TWICE , smile.gif
Image
User avatar
Ian Warren
NZFF Pro
 
Joined: Fri May 05, 2006 5:23 pm
Posts: 41187
Location: AREA 51


Return to Technical Issues

Who is online

Users browsing this forum: No registered users and 9 guests