The first couple of shots are at autogen setting 'normal'. The other two are Very Dense. (one less than full.)




100% ad-free
Adamski wrote:QUOTE (Adamski @ May 4 2010, 07:30 PM) <{POST_SNAPBACK}>BTW - is there anything that can be done about the default ground textures in FS? You know - the stuff that shows through the autogen - that awful "porridge"?
Currently, almost all default -- and addon -- ground textures which are landclass-based are at a resolution of 1.2 metres per pixel. You can go higher, but this is one of the most intensive uses of textures -- each square metre of land is textures, after all -- then most would find the default a reasonable compromise.
Because these textures are always there while you can see the ground, they rely greatly on mipmaps to keep performance up, so what you are probably seeing is lower mipmaps. So you might be seeing 2.4 metres per pixel, or 4.8, which was the default resolution of FS2004.
Lots of settings affect this, including the Texture Resolution, which MUST be set to at least 1 metre to see the default textures fully, and Global Texture Resolution, which should be set to at least High.
Flying fast can mean that your view outstrips the ability to load textures underneath you, which is why something slow is recommended for sight-seeing:)
By the way, VLC includes customised NZ bush ground textures, based on actual photos of, well, NZ bush. This is still 1.2 metres resolution though.
s0cks wrote:QUOTE (s0cks @ May 10 2010, 08:30 AM) <{POST_SNAPBACK}>I see your framerate is 16.8 with normal autogen, I daren't imagine what it is like at extremely dense settings. Will the VLC be an FPS killer?
I guess that would depend what sort of system Robins has..and a question I was going to ask - what is your system specs Robin if don't mind me asking?


Users browsing this forum: No registered users and 6 guests