Wellington FSX

[ronindanbo]

thought I owuld post this here it may be more noticeable

Hi Robin

I have just installed Welly in FSX and applied the patch, I have an issue where I think the AFCAC may be the default and there seems to be an incorrect landclass (waves under the taxiways ?) is there anything I can do to fix this??

[toprob]

Sorry, I did see the other post, but I put it on hold until I could come up with something. (I actually had to look at the patch to see what it did, it's been so long...)
Unfortunately I haven't heard of anything like this, so we might need to look a bit more.
The NZWN AFCAD is included in the RealNZwgtn\scenery folder, so this SHOULD always be accessible. The only reason why it wouldn't work is if there was a conflicting AFCAD-type file. (The likely location being Addon Scenery\Scenery)
The 'incorrect landclass' you mention sounds like the type of thing you get when a landclass scenery has a higher priority than the Wellington scenery. Any landclass should be tucked in before 'Addon Scenery' in the library, otherwise you may get it over-riding other scenery.

[ronindanbo]

Yeh Welly is at the top of the list, the only thing I can think of AFCAD wise is that I haf My Traffic X loaded up and I think it is an invassive peice of cr@p so I will look into that more.

[Timmo]

QUOTE (ronindanbo @ Dec 15 2007, 10:12 PM) <{POST_SNAPBACK}>

Yeh Welly is at the top of the list, the only thing I can think of AFCAD wise is that I haf My Traffic X loaded up and I think it is an invassive peice of cr@p so I will look into that more.

It sure is....and the un-installer doesnt clean up properly after itself either.