NZFF

by **stubbie** » Wed May 16, 2007 3:30 pm

Hi guys and girls,Ineed help.
Ever since Ive had fsx the choppers roll left and nothing i can do stops it It doesnt do it in fs9 and it doesnt do it to fixed wings ,any ideas would be a help. hope to get more involved with you all now as ive just left a stressful job and now have more time to sim.Regards all stubbie

by **ooOO00OOoo** » Wed May 16, 2007 4:22 pm

what are you realism settings like? I know that "general" adds rudder left to planes but i am not sure about choppers

by **Brennanx** » Wed May 16, 2007 4:24 pm

It goes left because of the way ur engine spins turn yaw of in ur realism settings i think it is.

by **ZÃƒÂ¶ltuger** » Wed May 16, 2007 4:26 pm

Brennanx wrote: It goes left because of the way ur engine spins turn yaw of in ur realism settings i think it is.

I think the setting is auto rudder. Could be the case, tho I'm not sure given it's not happening in FS9

by **stubbie** » Wed May 16, 2007 4:52 pm

Have flown choppers in fs9 ok did have the problem with winged aircraft but pushed ctrl x and all was well thinking maybe another key or another install which im trying to avoid for fsx just hoping

by **Brennanx** » Wed May 16, 2007 5:11 pm

Yea i woudnt think it was the engine spinning that way if it would move that much just saying that to o00000000oooooooo000. I know when i start up my fs it always has full right rudder on all i do is reverse it by going full left then full right and it fixes it.

by **stubbie** » Wed May 16, 2007 5:36 pm

Have the full ch set and all i can get is a controlled crash i tend to think if youre having same prob its in fsx.Downloaded a coup;e of new helos with the same prob

by **Bandit** » Wed May 16, 2007 9:20 pm

If you haven't already, try recalibrating your controls.

Possibly the joystick isn't centred?

Doesn't hurt to do this every now and again anyway.

by **creator2003** » Wed May 16, 2007 11:02 pm

Is the chopper the default or the dodosim206 in fsx ?as that is the clasic sign of that aircraft that just spins outta control ,the fix for that was rudder and axisbrake assignments or something along those lines ,but all choppers on different settings will react in different ways,in saying that i never had a problem even after put another cfg thats avalible from hovercontrol.com fsxbell CFG dynmics check it out

NZFF

Rolling choppers

Who is online