Troubles with 20m Mesh.

[Taurus548]

I purchased the above back in Sept 2005 and it has worked well for me.
Now I have had to reinstall FS2004 and I am trying to reinstall mesh 20 but with no success.
The CD autoplays and I have the first screen but when I click "installer" the PC seems to go into a loop. The CD is reading and the "red light" shows that the hard disk is "Read/Write" at full speed but it goes no where.
It is so hungry that "cntrl alt del" does not work and the only way to start again is to press the start button on the PC.
Any one else had this problem?
Any assitence appreciated!
P.S. Has anyone installed Mesh 20 on FSX?

[Christian]

Hi

I have to admit the CD installer is probably not as well done as it could have been...

The answer to your question is patience. The install file is 550MB and it can take quite a long time to fire up. If you want to have more direct control what's happening, simply copy the setup.exe from the CD onto your harddrive and run it from there. it will take a while to copy, but once it's copied over it'll run a lot faster...

The mesh works just fine in FSX (ie it's 100% compatible). If you're using FS2004 and FSX in parallel I recommend that you install for FS2004 and then copy the mesh folder into FSX and activate from within FSX. If you're just using FSX simply install as normal...

Cheers,
Christian