NZFF

I did a repaint for the wilco 737(pilot in command). Whenever you minimize the sim the textures go all fuzzy. How can i stop this?

I save in photoshop as a bitmap...32 colour.
In DXTBMP i save as extended bitmap DXT1(no alpha)
Scaling filter is set to none...and include 16 bit dither is unchecked.

Thanks in advance
James

Save as DXT3 no mips and the blurs go away.
I have no sound facts to back up this statement but it works for me.

Thanks for the reply, it is now working.
Now it swerves to the right. Is that meant to happen? How do i stop it? I reinstalled and it stopped but now its back.

ooOO00OOoo wrote:

QUOTE(ooOO00OOoo @ Aug 1 2007, 09:07 AM) <{POST_SNAPBACK}>

Thanks for the reply, it is now working.
Now it swerves to the right. Is that meant to happen? How do i stop it? I reinstalled and it stopped but now its back.

I found somtimes it a case off saving thru the switchs (ie:common saved format) and return to DXT3 , it almost as if the computer won't reconise the paint .

ooOO00OOoo wrote:

QUOTE(ooOO00OOoo @ Jul 27 2007, 10:07 AM) <{POST_SNAPBACK}>

Now it swerves to the right. Is that meant to happen? How do i stop it?

Not enough paint on the left wing. Add more paint.

Seriously, though, check the fuel/load dialog. You may have saved a flight at some point where there was an imbalance - more fuel taken from the left tank, all the pax sitting on the right etc...