NZFF

I downloaded Auckland Airports 2006 from Avsim and installed Robin's Auckland scenery which fixed most problems although my AI aircraft at Ardmore are hovering a foot or so above the airport - I have been told of some possible solutions to in another thread but none of them worked

Thanks Trolly, but doesn't it have to be set to 21 for the 20m mesh?

Naki wrote: I downloaded Auckland Airports 2006 from Avsim and installed Robin's Auckland scenery which fixed most problems although my AI aircraft at Ardmore are hovering a foot or so above the airport - I have been told of some possible solutions to in another thread but none of them worked

auckland_real_nz_airports.zip the file you need is in there...just follow the instructions and you'll suceed.
Nunner

Jenks wrote: - although most my airfields for some reason are now just above the ground or in shallow depressions

So are mine, and I have shiteloads of afcads all through my setup, I'm not sure where to start to clean them up

ok, just saw this for the first time.

What happens here is that the AI is at a different level as the mesh (probably caused by the airports need to be flat restriction). How to fix? Create a flatten at taxiway altitude around the whole airport. Flattens can be created as rectangles in the scenery.cfg, or as polygons using 3rd party software.

Hope that helps.

Cheers,
Christian

See the following link for flatten for Ardmore in Auckland Airports 2006, for 20m mesh.

http://z11.invisionfree.com/nzff/index. ... topic=2155

Lawrie.