NZFF

Heya,

I have a wee problem... How do I get rid of this?



Any help appreciated!

Thanks, KAG

Would probably need an exclude file (or entry fr your scenery.cfg file) Is that a default Afcad file or an addition? Also what airport is that at, someone here may have already fixed it

Its Palmerston North.

Its not a default, I created it. I was planning on uploading it, but not with a fuel pump in the way .

Any suggestions on how to do the exclude file?

Thanks Owen!

did you make the afcad ??if so you could remove it by remove fuel on the afcad ,,or go to scenerydesign.org and look up excbuilderv2 and use that to excule the object,always face 000 degrees 360 the same thing slew over the object then open excbuilder and press the buttons and bang restart should be gone.
looks good dude also excbuilder can only get rid of default scenery object not ones put in by bgl file from avsim etc ....