NZQN Queenstown Airport by Peter Lohr - WHITE aprons
Lately, I installed the superb scenery of NZQN Queenstown (New Zealand) by Peter Lohr. Naturally, I have the Red Baron payware mesh by Christian Stock.
Most of the airport ground surfaces (aprons, carparks etc) are all WHITE....
Apparently, the asphalt texture which paints the airport aprons and carparks is not showing up...
I have tried everything I can think of to solve this.
Placing ALL textures in the Main FS9 Texture folder.
Re-downloading all older 'Must haves' like Airport 210, VOD, Nova, etc.
All these were placed in the MAIN Texture folder of FS9 to ensure they ARE being loaded.
Unfortunately, since the airport was created using AIRPORT for Windows, any modifications made using AFCAD or AFX editor or ADE9x are buried UNDER the textures created by the older programme AIRPORT - which seems to place its polygons at a HIGHER layer than all the modern scenery programs.
Anyway, since this scenery has been downloaded by thousands of simmers,
with nobody mentioning this gross flaw, then it's probably something on MY setup that is causing this unfortunate WHITE polygons...which indicate a texture(s) is missing or NOT being loaded by FS9.
Anybody got any ideas as to what might cause this.....??
Some screenshots of these white textures at Queenstown are shown on this page:
http://www.fsdeveloper.com/forum/showthread.php?t=427355
Apparently, this is not an isolated incident. Others have run into these white textures at NZQN, and a patch used to be available at SDZN (Scenery Design New Zealand), Peter Lohr's site.
The mysterious thing is that it's NOT a universal problem, or Mr. Peter Lohr would have fixed it soon after launching and uploading it for all simmers.
Ronald
