NZFF

Hi All

I have the mesh, topo and landclass in and running fine.

The problem I have is that NZWF is too far to the south sitting in a ditch, on the wrong side of the road.

What can I do to fix this?

Cheers

Whose Wanaka are you using?

Alex

Just the default, I have not added anything yet.

When I put in an AFCAD for NZWF it appears in the correct place but there is still a big ditch in the hill where the spectators sit, and the new airport is not flat, trees etc on runway.

I have just reinstalled FS2004 after a coruption, NZWF was fine before.

I'd include a screen shot if I could work out how.

Cheers

Hmm, check out http://z11.invisionfree.com/nzff/index.php?showtopic=13 for info on how to take and upload screenshots.

Alex

The default Wanaka is on the wrong side of the road, as you've noticed, and the default Flatten cuts into the hill. There isn't much you can do about that, except remove the default Flatten.
Moving the airport via AFCAD is easy enough, but you would need to make a new flatten, and exclude the autogen somehow.
There is a fix for all this -- it's called Real New Zealand Wanaka:)