NZFF

I have today purchased and installed Hamilton X. It sure is an excellent piece of work by the author. However as I like to create AI from my own flight plans I seem to be having trouble with the supplied afcad. I can't get any aircraft to take off on the main runway 18 that have taxied over from the aero club side of the airport and any aircraft in the terminal taxing to use the main runway 36 like to taxi through the aero club grounds to get to it. I can open the afcad up in ADE and can see the problems that I need to fix. However when the afcad opens in ADE it also brings up the outline of the airport on a huge cement slab which when resaved appears on top of the scenery.
Does anybody know how to fix this? I don't have any other scenery design tools and have very limited experience and knowledge on this subject. Alternatively does anybody have a corrected updated afcad for Hamilton X.
Cheers,
Daryl

Just delete the huge cement slab.

Try the above with the afcad slab if that doesnt work ,send me all info on what you are trying to do via PM ill have a look at doing a fix for it ,i was just trying to see what you were trying to do and im unsure which parts you mean ,im no expert at traffic but willing to make a fix and have a link to update on site etc ..

Thanks for that I will try and delete the cement slab...... And thanks for the prompt reply. The aircraft parked over on the western side of the runway with the current afcad can never takeoff using the main runway 18. They just taxi down to the end and sit there. I think there is a short node missing in the taxi link just before they enter the main runway.
Cheers,
Daryl

sundayflyer wrote:

QUOTE (sundayflyer @ May 9 2011,10:39 PM) <{POST_SNAPBACK}>

The aircraft parked over on the western side of the runway with the current afcad can never takeoff using the main runway 18. They just taxi down to the end and sit there. .

This happens when there is no hold short node connected to the taxi link path or isn't close enough to the runway.