NZFF

Hi All,

Not sure if this is the correct place for this topic so sorry if its not right.

The issue (as it says) is with AI traffic, I have loaded the AIG traffic plans fo Air New Zealand, Qantas, and Jetstar, including Link for the Air NZ and Qantas. The problem is they all show up great at most airports including Christchurch, but nothing at Auckland or Wellington.

I have tried various AFcad files to no avail. I have tried deleating Fsx.cfg.

The aircraft in the plans is vertually the same for both Auckland and Christchurch so it would appear that they are OK.

Sliders are set at 100% for both GA and Airline Traffic

The only traffic that shows at Auckland is the NZBIZ aircraft and then not much

Not sure what else it could be, hopefully someone can point me at the problem

Regards
Stewart

Hey Stewart. Sounds like you may have a mix of FS9 and FSX AI flightplans, you may need to recompile them, check this post and the tool linked from it, should help:
http://nzff.org/forum/viewtopic.php?t=...p;#entry8275687

Hi Dean,

Thanks for the reply. You were spot on I had a FS9 file hiding (NZHELO_FSX) and although it said it was for FSX the flight Planner program said no and converted it. Thus problem solved, should have posted earlier instead of tearing what little hair I have left out!!!

I had assumed that if any FS9traffic files were in the system it suppressed ALL traffic not just at affected airports.

So a very big thank you.

Best Regards

Stewart

No problem, I know how frustrating it is so glad it helped