NZFF

Hey Rob, any idea what's happening here? All I have installed is what you see in the shot, plus the RBE 75m mesh (Placed under NZPP scenery in the scenery list)

victor_alpha_charlie wrote:

QUOTE (victor_alpha_charlie @ Apr 17 2008, 09:31 PM) <{POST_SNAPBACK}>

Hey Rob, any idea what's happening here? All I have installed is what you see in the shot, plus the RBE 75m mesh (Placed under NZPP scenery in the scenery list)

Maybe you're overloaded - too much super in the hopper

I see the taxiway is undulating as well. If an afcad file is used doesn't it use the specified airport height for all taxiways &/or runways so that if the mesh is installed as well the A/C contact point is the field height - not the terrain? Used to be overcome by having a flatten file.

Last time I had this was when I had multiple afcad files for the same airport. Check that?

Jamie

I will have a look at this, but haven't had time yet. My initial thought is that it isn't an AFCAD issue -- I've re-elevated NZPP from 6.7m to 15 metres, so it seems unlikely that you'd have an errant AFCAD close to by not quite 15 metres.