Page 1 of 1
Posted:
Tue Jul 03, 2007 4:08 pmby scon
Photoreal Picton is down below and the see through default runway hovers in the air, when I approach the R/W (the photoreal one) it goes fine untill about 50ft then I spring back up onto the default R/W. Howiever if a taxi off the one in mis air I fall back to earth, but get close to it and up I go again.
Regards, Scott
Posted:
Tue Jul 03, 2007 4:11 pmby VH-CC1
sounds like the afcads is too high off the ground.
Posted:
Tue Jul 03, 2007 4:53 pmby scon
VH-CC1 wrote: sounds like the afcads is too high off the ground.
But it is only doing it for the R/W
Posted:
Tue Jul 03, 2007 5:34 pmby VH-CC1
hmmmmmm.
Posted:
Tue Jul 03, 2007 5:35 pmby Chris Donaldson
Try -100ft off the runway elevation in the afcad.
Posted:
Tue Jul 03, 2007 5:47 pmby ardypilot
Firstly, is this Charl's modded GNZLAP afcad or the REAL NZ one that came with the package?
Secondly, what mesh are you using? What is your terrain_max_vertex setting?
Posted:
Tue Jul 03, 2007 6:43 pmby toprob
It certainly looks like you have a conflicting AFCAD.
Posted:
Tue Jul 03, 2007 7:49 pmby denisth
Check to see if you have the old flattens in scenery.cfg from Deane's old scenery.
It caught me out.
Posted:
Wed Jul 04, 2007 11:32 amby scon
This is in FSX I am using the Christians free 75m mesh, I don't think I have another AFCAD but will have a look
Posted:
Wed Jul 04, 2007 11:34 amby scon
Ah ha Jons "Compleat AI" came with a afcad have got rid of that now and will see if that works