NZFF

Installed Nelson no problems into P3D v4, have been flying around and looks great.
Flying over the pulp mill and noticed a few areas that just don't seem that should be there.
I am using Orbs scenery, FTX base Pack, and South Island, and FTX Vectors.

Is this ok? or what can be done to correct it ,thanks.



Steve

The edge of the Real NZ photoscenery is just outside the right-hand marking, so this is FTX NZSI landclass polys -- representing Nelson Pine Industries? When attached to commercial/urban landclass, this normally blends better, but in a rural setting it does stick out a bit -- which I guess is the same in real life:)
When I made Nelson, there wasn't always high quality aerial imagery available for free, so the imagery was limited. These days, I'd be more inclined to include photo scenery as far as you could see from the airport.
P.S. just saw your post count, welcome to NZFF! Glad you are enjoying the scenery.