NZFF

Have just done a clean install of FSX ,SP1. Acceleration & reinstalled all Robins scenery, however Tauranga sealed runway turns to grass ahead of my aircraft as I land. I had this a few years back but did not note the easy fix --If I remember right it was an easy fix--any help out there?? chrs

Good question -- I'll do some checking. However, in the meantime, does it help if you change the mesh resolution to 10 metres?

toprob wrote:

QUOTE (toprob @ Jan 7 2010, 02:50 PM) <{POST_SNAPBACK}>

Good question -- I'll do some checking. However, in the meantime, does it help if you change the mesh resolution to 10 metres?

I'll try that -- taking off from Tauranga is fine -- Rotorua is also great both in & out --I am sure I had a similarproblem when I changed to Vista --if I remember right it was one tiny file missing --- thanks alot

sounds like a flatten issue?

Timmo wrote:

QUOTE (Timmo @ Jan 7 2010, 05:10 PM) <{POST_SNAPBACK}>

sounds like a flatten issue?

Well the problem was DX9 again--no probs in DX10 --before my upgrade I was getting a terrible frame rates in DX9 but reasonable in DX 10-- since the upgrade DX 9 may be even better than DX 10---Still I,ll stick with 10 unless I take the ATR or the Mosquito for a spin. Just stay away from Tauranga & don't expect any screen shots.

Incidently do you chaps use the anti - aliasing built into the simulator or set it up in the ATI graphics menu. I have no luck at all using the ATI filtering. I do turn the sim anti-aliasing off when I experiment
Thanks

Hey there,
jsut a quick question...
What is the NDB frequency at NZTG?
I've tried 1670 & 346kHz but neither seem to work for me...

113.2?

That will work for the DME, but won't for the ADF...
I'll have another play with it today.

Btw, is there anything on the web to cross-reference nav-aid frequencies?
Every now and again You will find a VOR/DME/NDB/ILS frequency that doesn't correspond to Flight Sim.
In theory it should just be a matter of checking the plates/charts. But this isn't always so.

ctcav8r wrote:

QUOTE (ctcav8r @ Mar 7 2010, 06:41 PM) <{POST_SNAPBACK}>

That will work for the DME, but won't for the ADF...
I'll have another play with it today.

Btw, is there anything on the web to cross-reference nav-aid frequencies?
Every now and again You will find a VOR/DME/NDB/ILS frequency that doesn't correspond to Flight Sim.
In theory it should just be a matter of checking the plates/charts. But this isn't always so.

Try 304Khz

Bob R

304 in FS 2004 and FSX mate, think is one of the few ones in NZ that arn't the same as in FS as they keep changing the dam freqs to try and make reception better but so far makes no difference