NZFF

by **scon** » Tue Jul 03, 2007 4:08 pm

Photoreal Picton is down below and the see through default runway hovers in the air, when I approach the R/W (the photoreal one) it goes fine untill about 50ft then I spring back up onto the default R/W. Howiever if a taxi off the one in mis air I fall back to earth, but get close to it and up I go again.

user posted image

Regards, Scott

by **VH-CC1** » Tue Jul 03, 2007 4:11 pm

sounds like the afcads is too high off the ground.

by **scon** » Tue Jul 03, 2007 4:53 pm

VH-CC1 wrote: sounds like the afcads is too high off the ground.

But it is only doing it for the R/W

by **VH-CC1** » Tue Jul 03, 2007 5:34 pm

hmmmmmm.

by **Chris Donaldson** » Tue Jul 03, 2007 5:35 pm

Try -100ft off the runway elevation in the afcad.

by **ardypilot** » Tue Jul 03, 2007 5:47 pm

Firstly, is this Charl's modded GNZLAP afcad or the REAL NZ one that came with the package?

Secondly, what mesh are you using? What is your terrain_max_vertex setting?

by **toprob** » Tue Jul 03, 2007 6:43 pm

It certainly looks like you have a conflicting AFCAD.

by **denisth** » Tue Jul 03, 2007 7:49 pm

Check to see if you have the old flattens in scenery.cfg from Deane's old scenery.
It caught me out.

by **scon** » Wed Jul 04, 2007 11:32 am

This is in FSX I am using the Christians free 75m mesh, I don't think I have another AFCAD but will have a look

by **scon** » Wed Jul 04, 2007 11:34 am

Ah ha Jons "Compleat AI" came with a afcad have got rid of that now and will see if that works

NZFF

Picton is in the Air

Who is online